Posts

Showing posts from February, 2021

Going to be longer than I thought Voron 2.4

I recently found a printer that has really caught my even I want to build so bad unfortunately once I got the parts list and looked everything up it turns out it is a very expensive printer to build. This printer is the Voron 2.4 that I previously mention in my last post . So I will mostly slowly build up to getting everything for it but can’t throw down close to $2000 in parts at this time. Here is the build list with links and prices if anyone is interested though. Link I have found a slightly cheaper option but I am not 100% sure if it is the better option. AliExpress  Voron parts minus printed parts. Here are the printed parts that can be purchased from AliExpress .  This would put it around $1150 with shipping but it would take forever shipping from China.

New stuff and winter storm!

So I have been doing a lot of work since my last blog post. I moved platforms from Wix.com to Blogger.com and moved all of my content which took a bit. I also setup a YouTube channel to store my videos for this blog at and I planning on doing some vlog type content on it. I am not 100% sure how I plan on going about that but like everything it is a learning process while I go along. I got a new mainboard in for my Ender 3 which is the BIGTREETECH SKR E3 DIP V1.1 32 Bit + TFT35 V2.0 Display with 4pcs TMC2208 UART Kit . I have not gotten to print to much with it because I have been trying figure out to do my own Firmware configuration on it. I think I am close to getting it, been wanting to figure out how to set it up to be able to still use the Z end stop and the BLTouch off bed leveling. However, most information I find see on it most people just use the BLTouch for both.  I will probably end going this route and setting the bed up to being a fixed bed where I don’t have to mess with t