Failed Print!

Got another failed print. Made it 3/4 of the way through a 26hr print when it decided to jump off of the build plate.


The reason this was so long of a print was I did try using a smaller nozzle and slowing the print down because it is a miniature that I have tried to print several times but have been unsuccessful at. I think the only way I am going to be able to fully print this is if I get a printer that can support 2 filaments and run one of the filaments that can be dissolved in water like PVA Filament.



Comments

Popular posts from this blog

OctoPrint Camera Setting Rabbit Holes and lighting...

OctoLapse RAW Photo Settings

3D Printed Speaker part 1, upcycled Logitech X530 speaker